What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
13.06.2025 03:16

(Dc diagram shown, AC is similar).
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Barnstars:
a photo is worth a thousand words.
Because the load is inductive, the current lags the voltage.(by a bit).
If an abortion doesn’t affect you, why do people make it a big deal?
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is where the MOV conducts again, and dissipated the energy.
What are the most extreme examples of hypocrisy?
This device then solves the entire problem.
Upvotes:
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
At one ohm, the resistor has a maximum of 1 watt power.
The MOV will conduct when the voltage exceeds 50% of line voltage.
What have I done wrong? How can I start over?
These are simplified answers to the original question, and does not change anything I wrote above.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
This one hit behind the barn.
US Senate votes to move forward with GENIUS Act as stablecoin legislation picks up speed - The Block
First Sentence:
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Why is my crush beautiful to me but not to others?
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Here is a simplified AC power diagram.
Why cant I stop thinking about counsellor between sessions?
but I think this circuit , shows a few more pieces.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
The other is “what does a “fuse” do?”
What methods do private investigators use to investigate someone in real life?
One is “what exactly is in a ‘surge protector’ ? ”
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Will Canadians still buy American products?
[old diagram got deleted by accident]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
What does a fuse do?
This is 'the assistant's answer'
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
so, what happens?
The bolt then partially travels down the line to your home.
I post the exact comment here.
One
This is where this question deviates from being a 'generic' question, and becomes more specific.
An AC voltage/ current source, and an ac inductive load.
These devices are installed between the “hot” and “neutral” and protective ground.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
But it can get overloaded, and no longer works.
In schematic diagrams this is the symbol for a fuse:
The third is lightning and “how it gets conducted into a home.”
What is lightning?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Now when you have a certain ac resistance, then a current flows in a loop.
There are two important concepts here.
But… the neutral is now “floating” because of the 1 ohm resistance.
A fuse is a non-resetable over current circuit protector.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
what exactly is a ‘surge’ protector?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
A circuit breaker is similar, but is resettable.
[image of Common-mode choke]
but this device (an Inductor) … impedes the rapid changes in the current.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes Rainy Season and Lightning.
eight
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
At least they know the answer if they wanted it.
Edit 2024–10.
There are three different concepts here that are getting confused.
It seems Mohan does not understand the difference between a comment and an Answer.
nine
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
It also is a device that limits the change in current flow.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–10[John johnson John Johnson ]
For this case there are devices called Metal oxide varistors (MOV).
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
the problem then depends on "how fast does the fuse operate?".
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
2024–10–16 [ OO OLAOYE OYEBODE ]
He then describes the function of a fuse.
He then asserts :
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
Can the fuse protect the electronic devices from lightning instead of a surge protector.